I commented on a problem I had:
After running "KXStudio Welcome", all software running from Wine does not recognize the MIDI hardware (MIDI and USB).
"Jack_midi - port" "a2jmidid - port" and "Midi Through Port - (0 to 13)" were the visible options. In my particular case, it was impossible for me to use the editor for my Korg RADIAS. I tried all possible connections from these ports to my hardware, but it did not work.
I found the solution by stopping Jack from Cadence, then running the command "sudo rmmod snd_seq_dummy", "Force Restart" Cadence's button, then there Wine can properly recognize the hardware.
Can this be solved in upcoming versions of "KXStudio Welcome"?
Post fully complete "how to" guides and tutorials here. This is a great place to get feedback on stuff you might put in the wiki.
3 posts • Page 1 of 1
falkTX wrote:it's not cause by that, but rather a config file in kxstudio-default-settings
Edit /etc/modprobe.d/snd-seq-dummy_16.conf and lower the number of ports (say to 2), then reboot.
The problem is some applications not being able to recognize so "many" midi devices at once.
See if that works
You have solved the problem.
Who is online
Users browsing this forum: No registered users and 2 guests